10
2 USE
2.1 Controls
The screen has 4 displays with 7 segments each and gives information regarding
the current operation.
Press Start to start a program, pause or continue the program after the pause. In
the menu navigation use the ENTER function to enter or go the next level in a
menu.
Press advance to accelerate a program. When this key is pressed the programmer
goes directly to run the next cycle of the program; where the cycle currently running
is the last, the program ends. Please note that if you press this key during a spin
cycle, the machine will not move to the next cycle until completion of the required
safety time to permit the drum to come to a complete standstill.
This option is not available in self-service mode.
INC ( ) and DEC ( ) keys
The INC () and DEC () keys have different functions depending on the screen
and the programmer operating mode. Use these keys to select a wash program or
to scroll through different menus.
Use this button to scroll back through the different menus, or to end a program that
is running after pressing the START button.
The programmer has 6 amber LEDs that indicate the status of the washer extractor
and the progress of the washing program in its different cycles. The seventh LED is
green and shows the door status: if it is lit then the door can be opened, as the
drum is no longer moving.
2.2 Programs
Wash in cold water and two rinses
Wash at 104ºF and two rinses
Wash at 140ºF and two rinses
Wash in cold water and delicates spin
Wash in cold water and three rinses
Wash at 140ºF and three rinses
Default setting: Prewash, wash at 104ºF, three rinses and fast spin
NOTE: When the thermal stop is deactivated, the programmed wash time starts to run immediately without waiting for the programmed water
temperature to be reached.
To Next Page
