18
Iran, Islamic Republic of
NOTE: This list is continuously updated, if you cannot find your country in the
list, please ask your distributor for the latest available update.
5.5.7 TiMr (Wash time remaining)
This indicates the time remaining until the program
ends. The default setting is ON for all the programs,
but if the StOP option (Thermal stop, see section
5.5.10) is activated, the remaining time option is
automatically deactivated.
5.5.8 PAY (Operating mode)
This allows the machine operating mode to be
changed between CP MODE, COIN MODE & OPL
MODE (see section 5.4).
5.5.9 AVAn (Advance cycle)
This option is only available in OPL MODE. The key >
can be deactivated, to prevent the advance of a cycle
thus ensuring the wash program is completed
correctly. By default, it is ON.
5.5.10 StOP (Thermal stop switch)
This option is only available in OPL MODE. When the
thermal stop switch is activated, the cycle time does
not start until the programmed temperature has been
reached in order to guarantee the wash cycle is
correctly completed; this switch can be deactivated so
that the time is counted from the moment the
programmed level is reached. The default setting is
OFF.
5.5.11 Grd (Change between ºF & ºC)
This option is only available in OPL MODE. This
submenu allows you to select the temperature display
in degrees Fahrenheit (ºF) or degrees Celsius (ºC).
The default setting is degrees Fahrenheit.
5.5.12 Beep (Acoustic signal)
This option is only available in OPL MODE. This allows
you to switch the acoustic signals on or off. By default,
they are ON.
To Next Page
