17
5.5.4 ECL (Configuration of extended cycles)
Use the ECL submenu to change the length of each of
the cycles of the extended programs, P5 and P6.
The changes made will only apply to these two
programs.
The default times of each cycle and the range within
which they can be changed are as follows:
5.5.5 P7 (Configuration of the OPL program)
This option is only available when the machine is in
OPL MODE, therefore it is necessary to activate this
operating mode (see section 5.4.1).
The OPL program is independent to the other six
programs and it is possible to change more settings in
the program. It offers the option to add an additional
soak, prior to the prewash. In addition to the times for
each cycle, it is also possible to modify the wash
temperature and the spin speed.
The temperature of the wash cycle can be set between
cold water and 194ºF, with a default value of 104ºF.
The spin speed varies according to the type of washer
extractor: standard, medium or high speed.
Nevertheless, it is possible to change this speed and
establish a lower speed. This change will only affect
the maximum spin cycles, as the average spin is
always at 100G. The available speeds are as follows:
SP1: 100G (standard speed)
SP2: 200G (fast speed)
SP3: 350G (high speed)
5.5.6 Cur (Currency)
This is only available in COIN MODE (see section
5.4.2). This allows the currency to be selected. The
default currency of the coin slot is USD (Code 3), but it
is also possible to configure the machine for use with
other currencies. Please refer to the coin drop kit
manual and check whether the coin slot installed in
your machine accepts the currency used in your
country. Allocate the currency to the washer extractor
programmer. The table below shows the available
currencies is (Code 3) United States:
To Next Page
