113063- 11 www.adclaundry.com 43
WARNING: When cleaning steam coil fins, be careful not to bend the fins. If fins are bent, straighten
by using a fin comb, which is available from local air conditioning supply houses.
90 DAYS
Inspect and remove lint accumulation in customer furnished exhaust ductwork system from dryer’s internal
exhaust ducting.
WARNING: THE ACCUMULATION OF LINT IN THE EXHAUST DUCTWORK CAN
CREATE A POTENTIAL FIRE HAZARD.
WARNING: DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION
AIR.
WARNING: INSPECT AND REMOVE ANY LINT ACCUMULATION, WHICH CAN CAUSE
THE BACK DRAFT DAMPER TO BIND OR STICK.
NOTE: To remove the lint drawer from the dryer, pull the drawer out until it stops. There are two T-20
torx screws on each side of the lint drawer holding down the lint drawer catch brackets, which
must be loosened. Once they are loose the drawer
will be able to be pulled completely out of
the machine. To reinstall put the lint drawer back into the machine, line up the lint drawer catch
brackets with the screws and tighten them down.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shutdown of
heat circuit safety switches or thermostats.
NOTE: If the hi-limit trips due to a high temperature occurrence, you must disconnect power before
resetting. To reset, press and release the reset button, which is located on the top front, left
corner of the dryer.
NOTE: When cleaning the dryer cabinet(s), avoid using harsh abrasives. A product intended for the
cleaning of appliances is recommended.
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION AND EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, (bearing setscrews), and nonpermanent gas connections (unions, shutoff valves,
orifices, and grounding connections). Motor and drive belts should be examined. Cracked or seriously frayed
belts should be replaced. Tighten loose V-belts when necessary. Complete operational check of controls and
valves. Complete operational check of
ALL safety devices (door switches, lint drawer switch, sail switch,
burner, and hi-limit thermostats).
C. LUBRICATION
The motor bearings, idler bearings...and under normal/most conditions the tumbler bearings are permanently
lubricated. It is physically possible to re-lubricate the tumbler bearings if you choose to do so even though this
practice
is not necessary. Use Shell Alvania #2 or its equivalent. The tumbler bearings used in the dryer DO
NOT have a grease fitting. Provisions are made in the bearing housing for the addition of a grease fitting which
can be obtained elsewhere, or from ADC by ordering kit Part No. 882159, which includes two (2) fittings.
To Next Page
Loading...
