Need help?Do you have a question about the ADC ES35 and is the answer not in the manual?
Introduction to general safety guidelines and warnings for dryer operation.
Procedures for cleaning dryer components and exhaust systems.
Checks and adjustments for dryer components after installation and periodically.
Requirements for dryer enclosure, air supply, and exhaust.
Standards and codes for electrical and gas connections.
Procedure for verifying dryer operation and safety circuits.
Details on the dryer's control panel and its functions.
Description of Globar and Gas Burner Assembly.
Information on Drive Motor and Blower Motor.
Details on Tumbler, Door Switch, Sail Switch, and Thermostats.
Information on Lint Drawer and Lint Drawer Switch.
General guidelines and safety warnings for dryer servicing.
Procedures for replacing the dryer's computer.
Servicing procedures for Globar heating components.
Instructions for servicing various dryer thermostats.
Procedure for replacing and adjusting the sail switch.
Servicing steps for front panel and main door components.
Procedures for replacing the drive belt and motor.
Procedure for replacing the blower housing or motor.
Procedure for replacing the lint drawer switch.
How to view recorded faults and interpret event codes.
Using the diagnostic cycle to troubleshoot dryer issues.
Navigating the help menu to view component status.
List and explanation of help codes for dryer troubleshooting.
Diagnosing faults related to probes and sail switch.
Troubleshooting rotation sensor and high temperature faults.
Identifying and clearing blocked coin drop faults.
Understanding sensor and ignitor fault counts.
Interpreting exhaust high limit and bad coin count events.
Diagnosing rotation sensor and SAFE disabled events.
Explanation of information found on the dryer's data label.
Guide on how to use a manometer for pressure testing.
List of tools required for dryer servicing.
To Next Page
General
