Addmaster IJ-7100 - Self-Test Procedure

Addmaster Corporation IJ-7100 User’s Guide
Step #3: Finish.
Close the lid.
Tear off the excess paper using the Tear-Bar.
Test the printer by printing the Printer Status Info report. (Hold down the Go Button until printing
begins.)
3.4 Self-Test Procedure
After the printer is set-up and its supplies are loaded, its operation can be tested by use of the
printer’s “Self-Test Routine.” This self-test exercises most aspects of the machine’s operation
and provides visual indication that the unit is properly set-up and ready for operation. The
following features are tested and verified:
• Identification: Model Number, Firmware & Revision Level, Installed Options
• Operation: Printing, Feeding, Validation Clamping & Ejecting,
• Printing: All fonts and print modes.
To initiate the Self-Test, follow these steps:
1. Turn off power.
2. Hold down GO button.
3. Turn on power.
4. Release button after printing starts.
5. A sample tape is printed.
6. Press GO button again (short depression) and next message will print. Continue at step
6 as desired.
7. Insert Form to test validation mechanism. Push FEED button. Repeat step 7 or continue
at step 6.
IMPORTANT NOTE:
Unit exits self-test mode automatically after any communications.
_____________________________________________________________________________
Page 16