Addmaster Corporation IJ-7100 User’s Guide
Irregular Paper Feed
If the paper fails to properly feed into the unit, check the following:
• The paper being fed into the unit has a straight edge with no bends,
• The paper roll can rotate freely on its supports.
Potential Validation Document Problems
The validation document needs to properly cover internal sensors before validation can begin.
Cut-forms, if designed improperly, may cause problems. Check for these items:
• Is cut-form large enough? If it is too small (less than 6 inches), it may not cover both
sensors. The type and use of the chrome form guide will affect this also.
• Are there any holes in the cut-form? These may prevent proper feed.
Computer Interface Not Working, Hung, or Dead
This is the most common problem, probably because so many different set-up problems can
cause it.
If the computer interface WAS WORKING, but now is not, then check:
Awaiting Cut-form If the FORM LED is ON, then the unit requires a cut-form to
continue.
Form Jam or
Mechanism Jam
If the ERROR LED is FLASHING, then either a document is stuck
in the unit, or the print-head is jammed and cannot move. Correct
the problem. You may have to turn power on and off.
Computer Cable Insure that the communications cable has not been removed.
_____________________________________________________________________________
Page 18
To Next Page
Loading...