53
Weather Station with Wireless Outdoor Sensor WS 1502/1503
English
Start-up
Proceed in the order specied below and rst
insert the batteries into the outdoor sensor.
Only then can the weather station function
without aws.
Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V).
This aects, among other things, the precision
of the measurements.
Where possible, use alkaline rather than zinc-
carbon batteries. Alkaline batteries last longer,
especially at low outdoor temperatures.
Outdoor sensor
1. Remove the battery compartment cover on the rear
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
3. Slide the battery compartment cover back into place
on the outdoor sensor.
FW Station.indb 53 21.09.2015 09:45:59
To Next Page
Loading...
Need help?
General
