ADEEPT Hexapod - Table of Contents

www.adeept.com
1
contents
1. component List
........................................................................................................................................................
2
1.1. Acrylic Plates
............................................................................................................................................
2
1.2. Machinery Parts
................................................................................................................................
3
1.3. Electronic Parts
.................................................................................................................................
4
1.4. Tools
..................................................................................................................................................
6
1.5. Self-prepared Parts
................................................................................................................................
6
2. Assembly
..................................................................................................................................................................
6
2.1 Install and Remove Batteries
.....................................................................................................................
6
3.Instal the driver
.........................................................................................................................................................
7
3.1 install Arduino IDE
.....................................................................................................................................
7
3.2 Configure Environment
............................................................................................................................
10
3.3 After uploading, turn of the power and switch to 1, and then turn it on.
..............................................
19
4. Assemble the body
................................................................................................................................................
22
4.1 Assemble the legs of the robot
............................................................................................................
22
4.2 Assemble the body and rocker arms
...................................................................................................
31
5. Instal the upper computer control software .
.......................................................................................................
46
5.1 Control the robot. .
..................................................................................................................................
50
5.2 Common issues
........................................................................................................................................
51
5.3 Mobile phone control
..............................................................................................................................
51
6. Open the software and you can control.
...............................................................................................................
53