OPERATING INSTRUCTIONS
DMX State: This mode is used as a precaution mode, that in case the DMX signal is lost, the operating
mode chosen in this setup is the running mode the xture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the unit to return to when power is applied.
1. Press the MODE button until the DMX address is displayed. Press the ENTER button until either
“Soun,” “HOLd,” or “bLC” is displayed.
2. Use the UP or DOWN buttons to nd the desired mode of operation in the event that the DMX
connection is lost.
• “bLC” (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• “HOLd” (Last State) - If the DMX signal is lost or interrupted, the x-ture will stay in the last DMX
set up. If power is applied and this mode is set, the unit will automatically go into the last DMX
set up.
• “Soun” (Sound Active) - If the DMX signal is lost or interrupted, the unit will automatically go
into sound active mode.
3. Find your desired setting and press ENTER. Your setting will be saved automatically.
11
To Next Page
Loading...
