ADJ 18P Hex - M U Lt I P L E U N I T P O W E R L I N K I N G

PRIMARY-SECONDARY CONFIGURATION
This function will allows you to link units together to run in a Primary-Secondary mode. In Primary-
Secondary operation, one unit will act as the controlling unit and the others will react to the controlling
unit’s built-in programs. Any unit can act as a Primary or as a Secondary, but only one unit can be
programmed to act as the “Primary.”
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables
to link your units together. Remember that the Male XLR connector is the input and the Female XLR
connector is the output. The rst unit in the chain (primary) will use the female XLR connector only.
The last unit in the chain will use the male XLR connector only.
2. Set the “Primary” unit to your desired mode of operation.
3. Connect the rst “Secondary” unit to the “Primary.”
4. On the “Secondary” unit press the MODE button until “SEcd” is displayed. The “Secondary” unit
will now follow the “Primary”.
MULTIPLE UNIT POWER LINKING
With this feature you can connect the xtures to one another using the power input and output sockets.
The maximum quantity that can be connected in this manner is as follows:
• 4xturesmaximumfor120V
• 8xturesmaximumfor240V
DO NOT EXCEED THE NUMBER OF UNITS AS LISTED ABOVE.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES TO THE 18P HEX. POWER
CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY. ALWAYS CHECK THE MAX AMP
OUT RATING OF EACH FIXTURE!
12