To Next PageTo Next PageWhat to do if ADJ Flood Light has no output?
If your ADJ Flood Light has no output, ensure it's connected to a standard wall outlet. Also, check the external fuse at the rear of the unit to see if it has blown. Finally, make sure the fuse holder is completely and properly seated.
Why does my ADJ 4 STAGE PAK Flood Light not react to sound?
Your ADJ Flood Light may not react to sound because it responds best to low frequencies (bass). Tapping on the microphone or using quiet, high-pitched sounds may not activate the unit. Also, check the Mic setting, as it might be set to a lower sensitivity.
Setting up the unit in DMX mode, including address configuration.
Configuration for sound-activated modes and DIP switch settings.
Instructions for selecting and controlling mixed colors using DIP switches.
Manual control of Red, Green, and Blue colors via DIP switch settings.
Information about the unit's auto-sensing electronic ballast for power input.
Explanation of the DMX-512 protocol and its use in lighting control.
Guidance on connecting multiple DMX fixtures in a chain for synchronized operation.
Specifications for DMX cables, including type, shielding, and connectors.
Guidance on using terminators for reliable DMX signal transmission over long cable runs.
Procedure for cleaning the unit's exterior using glass cleaner and a soft cloth.
Important step to ensure all parts are completely dry before re-plugging the unit.
Troubleshooting steps for when the unit fails to produce light output.
Steps to resolve issues where the unit is unresponsive to audio input.
Setting up the unit in DMX mode, including address configuration.
Configuration for sound-activated modes and DIP switch settings.
Instructions for selecting and controlling mixed colors using DIP switches.
Manual control of Red, Green, and Blue colors via DIP switch settings.
Information about the unit's auto-sensing electronic ballast for power input.
Explanation of the DMX-512 protocol and its use in lighting control.
Guidance on connecting multiple DMX fixtures in a chain for synchronized operation.
Specifications for DMX cables, including type, shielding, and connectors.
Guidance on using terminators for reliable DMX signal transmission over long cable runs.
Procedure for cleaning the unit's exterior using glass cleaner and a soft cloth.
Important step to ensure all parts are completely dry before re-plugging the unit.
Troubleshooting steps for when the unit fails to produce light output.
Steps to resolve issues where the unit is unresponsive to audio input.
Power| voltage | 100-240V AC/47 – 63Hz |
|---|---|
| power consumption | 18W max. |
Lighting| led power | 36W (36x1W) |
|---|---|
| led configuration | 12 x Red, 12x Green, 12 x Blue |
| dmx channels | 6 |
Weight and Dimensions| dimensions | 280x260x260mm |
|---|---|
| weight | 2.56 kg |
