To Next PageTo Next PageHow to fix ADJ XS 600 Flood Light with no light output?
If your ADJ Flood Light has no light output, start by checking the external fuse located on the rear panel to ensure it hasn't blown. Also, make sure that the fuse holder is completely and properly seated.
What to do if ADJ Flood Light does not respond to sound?
If your ADJ Flood Light isn't responding to sound, first ensure that the sound source has low frequencies (bass), as the unit is designed to react to these. Tapping the microphone or using quiet, high-pitched sounds may not activate it. Also, check the sound sensitivity level and ensure it is not set too low.
How to set the DMX address and select DMX channel modes.
Procedure for setting the unit as a master or slave in a master/slave configuration.
Performing function tests and resetting the unit to factory defaults.
Controlling the fixture using a DMX controller and its capabilities.
Steps for linking multiple units together in a master-slave setup.
Instructions for safely replacing the unit's fuse.
Common problems and their solutions for the XS 600 fixture.
Details of the manufacturer's limited warranty period and terms.
How to set the DMX address and select DMX channel modes.
Procedure for setting the unit as a master or slave in a master/slave configuration.
Performing function tests and resetting the unit to factory defaults.
Controlling the fixture using a DMX controller and its capabilities.
Steps for linking multiple units together in a master-slave setup.
Instructions for safely replacing the unit's fuse.
Common problems and their solutions for the XS 600 fixture.
Details of the manufacturer's limited warranty period and terms.
Power| voltage | 100V ~ 240V/50~60Hz |
|---|---|
| power consumption | 60W |
| fuse | 1A |
Lighting| LEDs | 6 x 10W RGBW 4-in-1 LEDs |
|---|---|
| beam angle | 5 Degrees |
| colors | RGBW Color Mixing |
Weight and Dimensions| dimensions | 196 x 126 x 318mm |
|---|---|
| weight | 3 kgs |
| length | 7.75 inches |
