User Instructions
7/17
ELEMENT QA
©2017 ADJ Products, LLC all rights reserved. Information, specications,
diagrams, images, and instructions herein are subject to change without
notice. ADJ Products, LLC logo and identifying product names and numbers
herein are trademarks of ADJ Products, LLC. Copyright protection claimed
includes all forms and matters of copyrightable materials and information
now allowed by statutory or judicial law or hereinafter granted. Product
names used in this document may be trademarks or registered trademarks
of their respective companies and are hereby acknowledged. All non-ADJ
Products, LLC brands and product names are trademarks or registered
trademarks of their respective companies.
ADJ Products, LLC and all aliated companies hereby disclaim any and all
liabilities for property, equipment, building, and electrical damages, injuries
to any persons, and direct or indirect economic loss associated with the use
or reliance of any information contained within this document, and/or as a
result of the improper, unsafe, unsucient and negligent assembly, installa-
tion, rigging, and operation of this product.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC RADIO FREQUENCY INTERFERENCE WARNINGS & INSTRUCTIONS
This product has been tested and found to comply with the limits as per Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This device uses and can radiate radio frequency energy and, if not
installed and used in accordance with the included instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to radio or television recep-
tion, which can be determined by turning the device o and on, the user is encouraged to try to
correct the interference by one or more of the following methods:
· Reorient or relocate the device and/or antenna.
· Increase the separation between the device and the receiver.
· Connect the device into an electrical outlet on a circuit dierent from that which the radio
receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
Europe Energy Saving Notice
Energy Saving Matters (EuP 2009/125/EC)
Saving electric energy is a key to help protecting the enviroment. Please turn
o all electrical products when they are not in use. To avoid power consump-
tion in idle mode, disconnect all electrical equipment from power when not in
use. Thank you!
Date
Document
Version
Software
Version
DMX
Channel
Mode
Notes
>
DOCUMENT VERSION
Please check www.adj.com for the latest revision/update of this guide.
09/11/17
1.2
1.01
4/5/6/9/10 ETL Version
To Next Page
Need help?
General
