ADJ ELEMENT QA - DMX Addressing

ADJ Products, LLC - www.adj.com - Element QA User Manual Page 12
Element QA DMX Control
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Element QA has 5 DMX modes: 4 channel mode, 5 channel mode,
6 channel mode, 9 channel mode, and 10 channel mode. See pages 13-15 for each mode’s DMX
traits.
1. This function will allow you to control each individual fixtures traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until “d.XXX” is displayed. “XXX” represents
the current displayed DMX address. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes
are listed below:
• To run the 4 Channel Mode, press the MODE button until “Ch04” is displayed.
• To run the 5 Channel Mode, press the MODE button until “Ch05” is displayed.
• To run the 6 Channel Mode, press the MODE button until “Ch06” is displayed.
• To run the 9 Channel Mode, press the MODE button until “Ch09” is displayed.
• To run the 10 Channel Mode, press the MODE button until “Ch10” is displayed.
4. Please see pages 13-15 for DMX values and traits.
5. After you have chosen your desired DMX address and channel mode plug in the fixture via the XLR
connections to any standard DMX controller.