ADJ Products, LLC - www.adj.com - Element QA User Manual Page 21
Auto Run Mode:
There are 3 types of Auto Run Modes to choose from; Color Fade, Color Change, and both color
change and color fade modes running together. The running speed is adjustable in all 3 modes.
1. Plug the fixture in and press the MODE button until either “AFXX”, “AJXX”, or “A-JF” is displayed.
• AFXX - Color Fade mode, there are 16 Color Fade modes to choose from. Use the UP or DOWN
buttons to scroll through the different Auto Fade modes.
• AJXX - Color Change mode, there are 16 Color Change modes to choose from. Use the UP or
DOWN buttons to scroll through the different Auto Change modes.
• A-JF - Both Color Fade and Color Change modes running.
2. After you have chosen your desired running mode press the SET UP button until “SP.XX” is displayed.
When this is displayed you can adjust the running speed of your desired program. Use the UP
or DOWN button to adjust the speed between “SP.01” (slowest) and “SP.16” (fastest). Once you
have set your desired running speed, press the SET UP button to return to your selected Auto
Run mode.
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Element QA has 5 DMX modes: 4 channel mode, 5 channel mode,
6 channel mode, 9 channel mode, and 10 channel mode. See pages 14-15 for each mode’s DMX
traits.
1. This function will allow you to control each individual fixtures traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until “d.XXX” is displayed. “XXX” represents the
current displayed DMX address. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes
are listed below:
• To run the 4 Channel Mode, press the MODE button until “Ch04” is displayed.
• To run the 5 Channel Mode, press the MODE button until “Ch05” is displayed.
• To run the 6 Channel Mode, press the MODE button until “Ch06” is displayed.
• To run the 9 Channel Mode, press the MODE button until “Ch09” is displayed.
• To run the 10 Channel Mode, press the MODE button until “Ch010” is displayed.
4. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections
to any standard DMX controller.
Dimmer Curve:
This is used to set the dimmer curve used with DMX mode. See page 25 for the dimmer curve chart.
1. Plug the fixture in and press the MODE button until “d.XXX” is displayed. “XXX” represents the current
displayed DMX address.
2. Press the SET UP button until “dr-X” is displayed. “X” represents the current displayed dimmer
curve setting (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your desired dimming curve.
Element QA Operating Instructions
To Next Page
Loading...
