ADJ ENTOUR CHILL - Trouble Shooting; Breaker Reset; Error Warnings

ADJ Products, LLC - www.adj.com - Entour Chill User Manual Page 15
Entour Chill Trouble Shooting
This unit is equipped with a built-in no-fuse breaker (NFB). This breaker is designed to close the power
circuit in the event of an internal short or power surge. The fuse will reduce the risk of electrical shock
or re and protect the circuitry. To reset the breaker, push the breaker button in until you hear it “pop”
back in to place. If the fuse continues to trip, stop using the unit, and contact our customer support
team, it may need to be returned for service.
Entour Chill Breaker Reset
Power Connected but No Smoke is Emitted:
1. Check the power supply. Plug the unit into a grounded electric power supply socket with proper
voltage.
2. Disconnect the machine from the power supply and reset the built-in breaker.
3. Be sure there is sufficient fluid in the tank.
If you experience low output, pump noise, or no output at all, disconnect and discontinue use immediately.
Do not attempt to continue pushing the manual fog button as this may damage the machine. Check
the fluid level and the breaker, and be sure the wall outlet is sending power. If all these appear to be
operational, and the device still fails to operate correctly, the unit will require service. Please contact
ADJ Products, LLC.
Entour Chill Error Warnings
The following error warning messages may appear on the LCD screen, indicating a problem pre-
venting the device from operating correctly. Do not operate the unit while these error messages are
present to avoid further damage to the equipment. If these error messages persist, contact ADJ
customer service for help.
Heater Overheat: The heater temperature is excessively high, or the temperature sensor is malfunc-
tioning. The tank light will also ash red and green if this problem occurs.
No Heating: The heater is inoperational. The tank light will also ash red and green if this problem
occurs.
No Fluid: The uid tank is empty, or the pump has stopped. Please note that the pump stops auto-
matically when the uid tank is empty to avoid damaging the device. After relling the uid reservoir,
pressing the STOP button will clear this warning.