ADJ VF VOLCANO - Product Operation and Features; Description; Setup

7
1. Open the shipping carton and carefully remove the unit from the shipping carton. Remove all
packing material, paying particular attention to the area around the nozzle.
2. Set the fog machine on a at dry surface. Fill the fog uid reservoir with ADJ brand fog juice only,
then tighten the cap. NOTE: The glowing red LED indicates that the reservoir has enough fog
uid. If the red LED begins to ash, this indicates that the machine is running low on fog uid.
3. Plug the unit into a matching power supply. Wait for the fogger to reach normal operating tem-
perature. The green LED on the rear of the unit will illuminate once the unit has reached operating
temperature, indicating that the unit is ready to emit fog.
4. Either press the fog button located on the rear of the unit, or press one of the remote buttons, in
order to emit fog. See the Wireless Remote Operation section of this manual for details.
SET UP
This device features a uid level sensor. The sensor LED will glow steadily when the uid resevoir
has sucient uid, or ash when the uid level is low. When the uid level approaches empty, a built-
in sensor inside the reservoir will automatically shut o the pump in order to protect the pump and
maximize its service life. This device also includes a new heating element that has been specially
designed to prevent excessive particle build up that can cause premature fogger failure. Additionally,
this device includes a wireless remote control with the ability to control LEDs and fog output.
DESCRIPTION