Admiral PAC - Cooling and Dry Mode Operation; Cooling Mode Operation; Dry Mode Operation

PAC USER MAN final 3/2/05 11:58 AM Page 14 O
OPERATIONiNSTRUCTiONS
If you want to cool the room, you can operate the appliance as follows:
1. Press MODE button and select cooling mode.
2. Press FAN button to select the fan speed you need.
3. You also can set the appropriate temperature by using the temperature
button.
4. When all the above is done, you can press ON/OFF button to make the
appliance run with cooling mode.
5. You can adjust the fan direction by pressing swing button, press once
for swing, and press again to stop.
< IV0JE
The appliance also gives you the function of drying.
1. Press MODE button and press select dry mode.
2. You can set the appropriate temperature by using the temperature button.
3. Press ON/OFF button to make the appliance run with dry mode.
4. You can adjust the fan direction by pressing SWING button, press once for swing,
and press again to stop.
I
i
Note: • Dry mode cannot be used to cool the room.
• It requires hot air outlet hose in Dry mode.
• In drymode, fan speed ispreset byappliance, so fan button is notapplicable.
1. If you select cooling or dry mode while appliance is in another mode, the compressor
wilt be delay-protected. Wait for 3-5 minutes, the appliance will run again. Do not
press any button during the waiting time, or the appliance will re-count the protected
time.
2. In cooling or dry mode, when the room temperature is up to set the temperature, the
compressor will stop running, and fan only is at rest.