PAC USER MAN final 3/2/05 11:58 AM Page ii C
iNSTALLATiONiNSTRUCTiONS
• Beside a window, a door, or a sliding door.
• Keep the required distance from the return air outlet to the wall or other obstacles at least 50cm ,(19.5")
• Fix one end of the air hose on the air intake or outlet underside the appliance.
• Extend the air hose to insure other end of the air hose has clearance between the window, door,
sliding door, or wall hole.
• Air outlet or intake cannot be blocked by protective grid or any obstacle.
• The distance between the two ends of the air hose should be kept at 200mm minimum, (8")
Note: the cooling capacity will decrease when using a single air hose, but air outlet temperature
gets lower, and a particular point in the room will cool faster.
• Air outletor intake indoor side cannot be blocked bya curtain, or anyobstacle.
• The end of the air hose cannot be blocked bya shutter or any obstacle.
• Do not bend theair hosewhen assembling, keep itstraight asin figure 3.
When appliance is in cool or dry mode, condensation will concentrate in water box of chassis-
when the box is full, water full indicator shows on red, LCD window appears the wrong sign E.
The appliance stops running at the same time. Now the power supply should be shut off. Next,
pull out the rubber plug in the drain port of the appliance, drain the water into a prepared container,
or drain the water by moving the appliance to a suitable place.
Note: water should be drained out when the water full light on, otherwise, the appliance will not work when
you start it again.
........'=i=%1 ,_
Before staring this unit
1. Select a suitable location, making sure you have easy access
to an electrical outlet.
2. Install the flexible exhaust hose and adjustable window slider
kit as depicted in Fig.1.
Note: 1. Step 2 is required only while using cooling or dry mode,
in cooling mode you can select to install two hoses or air
outlet hoses only, in dry mode you may install air outlet
hose only.
2. While running or installing, the hoses cannot be blocked Fig. 1
by curtains or any obstacle.
3. Plug the appliance into a grounded electrical outlet. Please select an appropriate power
supply.
4. To turn the appliance on, press On/Off button.
Note: Do not use a regular extension cord./fit is necessary to use an extension cord with this unit,
use an approved "air conditioner" extension cord only.
(Available at most local hardware stores)
To Next Page
Loading...
