PAC USER MAN final 3/2/05 11:58 AM Page 15 O
OPERATIONiNSTRUCTiONS
Press the SMART button, the unit enters smart mode(fuzzy logic operation) directly whether
the unit is on or off. In this mode, temperature and fan speed are automatically set based on the
actual room temperature.
Press the FAN button in sma[},mode, if the appliance is in cooling mode, fan speed
changes in turns: Auto-High-Low; if the appliance is in dry mode, the LCD displays as
figure on the right, but in fact, there is Auto-speed only.
Cooling only models
Indoor temperature Operation mode
°F
26°C (79°F) or below DRY
Over 26°C (79°F)
Target temperature
Room temperature
decrease 1.5 after
operate for 3 minutes
COOLING 26°C (79°F)
SMART button is ineffective in SUPER mode.
Note: Temperature, airflow and direction are controlled automatically in SMART mode.
However, a decrease or rise of up to 1 "C (2) can be set with the remote controller or
control panel if you still feel uncomfortable.
Your feeling
Slightly warmer
A decrease up to
2°C (4°F) can be set
Slightly cooler
A rise up to
2°C (4°F) can be set
Uncomfortable
because of
unsuitable air
flow volume.
Uncomfortable
because of
unsuitable flow
direction.
button
%
%
adjustment procedure
_\ Press once to lower the High
set temp by 1°C (2°F) Low
Press twice to lower the
set temp by 2°C (4°F) Lo_
Press once to raise the High
set temp by 1°C (2°F) Low
_\ Press twice to raise the High
set temp by 2°C (4°F) Low
Fan speed alternates among High and
Low each time this button is pressed.
Press it once, the vertical adjustment
louver swings to change vertical airflow
direction. Press it again, swings stops.
Note: There is no swing button on the control
panel, if you hold down FAN button 3 seconds,
it can realize swing function on the control
panel. Hold down the FAN button 3 seconds
again, you cancancel it.
To Next Page
Loading...
