PAC USER MAN final 3/2/05 11:58 AM Page 20 O
TROUBLESHOOTING
The following cases may not always be a malfunction, please check suggestions below before asking
for service,
Does not run
Runs for a short while only
I
Runs but not cooling
Water leaks durin(
moving
I
Does not run and water full
indicator lights
• If the protector trip or fuse is blown.
• Please wait for 3 minutes and start again,
protector device may be preventing unit from
working.
® If batteries in the remote controller exhausted.
• If the plug is not properly plugged in.
e If the set temperature is close to room
temperature, you can lower the set temperature.
• Air outlet blocked by obstacle.
Take the obstacle away.
• If the door or window is open.
• If there is another heating appliance working.
like heater or lamp, etc..
o The air filter is dirty, please clean it.
o Air outlet or intake blocked.
• Set temperature is too high.
• Drain the condensate before moving.
• Pull out the rubber plug to drain water.
® If it is often in this state, please contact
qualified service technicial.
To Next Page
Loading...
