Caution: Use the power adapter provided. Using a different
power adapter may result in hardware damage.
2.3 Final Steps
• Check LED Status
- The LED lights up solid blue then blinks ten times during startup,
which takes about 30 seconds. After startup is completed, and
prior to enrollment, the power LED blinks green/amber.
• Enroll the Camera
- The process for enrolling the camera on Control is described in
Section 3: ADT Control Enrollment.
- The process for enrolling the camera on Pulse is described in
Section 4: ADT Pulse Enrollment.
• Mounting the Camera
- Mount the camera in its final permanent location. For mounting on
a wall using the mounting bracket, see Section 5: Wall Mounting.
3 ADT Control Enrollment
This section provides instructions for wirelessly enrolling the OC845 Outdoor
FHD Camera onto the ADT Control platform. This process uses the Soft AP
method to wirelessly connect the FHD Camera to the Customer’s network.
3.1 Using Soft AP to Enroll Camera
• Set up the camera as described in the previous section.
- Connect the camera’s AC power adapter and plug it into a power
outlet.
- Wait for the power LED to blink green/amber.
To Next Page
Loading...
Need help?
General
