• Wait until the LED is lit solid green, and then disconnect the camera from
power.
• Install the camera in its final location.
- Please refer to Section 5: Wall Mounting
5 Wall Mounting
This section provides details for final mounting of the OC845 Outdoor FHD
Camera. You should ensure that the camera is configured and enrolled in the
platform before permanently mounting it.
• Locate an unused, non-switchable, indoor outlet to plug the AC/DC Power
Adapter into. This outlet should be located as close as possible to the
location where the camera will be permanently mounted.
Caution: Do not plug in the power adapter until all the connections
are completed and the camera is fully mounted.
• Run the supplied power cable from the outdoor location where the camera
will be mounted to the power outlet.
• At the location where the camera will be mounted, unscrew the camera
stand and remove it from the camera.
• Hold the stand at the location where you would like to mount the camera
and mark the location of the two mounting holes.
• Drill two holes on the mounting surface at the marked location.
• If using the anchors, insert them into the mounting holes.
• Align the two mounting holes on the camera stand with the two holes and
mount the stand to the surface using the two supplied screws.
• Attach and screw the camera onto the camera stand.
To Next Page
Loading...
Need help?
General
