TSSC System Manual
https://alpha.adt.com/help/65[11/12/2018 9:42:14 PM]
9. Lastly, click ‘Stop Test’ in ‘System Management.
Note: If test mode is inadvertently left active, it will turn off after 30 minutes.
Note: During the last 5 minutes of test mode, the keypad will double beep every 30 seconds.
To learn more about testing your system, please visit System Testing
.
Other System Information
Resetting the Time
Your system may require time resetting after a battery replacement.
To reset your system's time:
1. Enter your [security code] + [#][6][3].
2. Press [*] when the time/date is displayed. To move curser ahead, press [*], to go back press [#].
3. Enter the 2-digit hour and minute setting. Press [1] for AM and [2] for PM.
4. To exit, press [*] when the curser is on the last digit or wait 10 seconds.
Routine Care
Treat the components of your security system as you would any other electrical equipment. Do not slam
sensor-protected doors or windows.
Keep dust from accumulating on the keypad and all protective sensors, particularly on motion sensors
and smoke detectors.
The keypad and sensors should be cleaned carefully with a dry soft cloth. Do not spray water or any other
fluid on the units.
Other System Information
Communicating with the Panel
Your system can be set up to communicate with you through:
Status beeps
Alarm sirens
Touchpad text
Pager information
Instructing the Panel
To Next Page
Loading...
