Adtech CNC9960 - Page 159

ADTECH9 Series CNC Maintenance Manual
- 154 -
046 X-axis single-turn offset (mm/turn)
Y-axis single-turn offset (mm/turn)
Z-axis single-turn offset (mm/turn)
A-axis single-turn offset (mm/turn)
B-axis single-turn offset (mm/turn)
C-axis single-turn offset (mm/turn)
Range : -9999.999 ~ 9999.999
Unit :
Authority : Super Admin
Default : 0
Effective time : Instant
Note : It is used to set the screw moving distance after servo rotates a turn
(usually be used by the absolute servo motor or ETherCAT bus servo in
setting movement per revolution. Note: After setting this parameter for
bus controller, it is not necessary to set P2 parameter 001 multiplication
ratio and frequency division coefficient)
047 X-axis absolute encoder origin calibration
Y-axis absolute encoder origin calibration
Z-axis absolute encoder origin calibration
A-axis absolute encoder origin calibration
B-axis absolute encoder origin calibration
C-axis absolute encoder origin calibration
Range : -9999.999 ~ 9999.999
Unit :
Authority : Super Admin
Default : 0
Effective time : Instant
Note : To set the absolute encoder servo origin position calibration for the
ETherCAT bus
048 X Servo Driver Type
Y Servo Driver Type