Total Access 600 Series User Manual © 2002, ADTRAN, Inc.
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 26
Previous Transfer Status
Indicates the status of the previous update.
Load and Use Config
Retrieves the configuration file specified in the 7)736
(59(5
)
,/(1$0(
field from the server. To start this
command, enter
<
to begin or enter
1
to cancel.
Save Config Remotely
Saves the configuration file specified in 7)736
(59(5
)
,/(1$0(
to the server identified in 7)73
6
(59(5
,3$
''5(66
. To start this command, enter
<
to begin or enter
1
to cancel.
>Ping
Allows you to send pings (ICMP requests) to hosts. The following items are under this menu:
Start/Stop
Activator to start and cancel a ping test.
Host Address
IP address or domain name (if DNS is configured) of device to receive the ping.
Size (40-1500)
Total size of the ping to send. Range is 40 to 1500 bytes. 64 is default.
# of Packets
Total packets to send every 2 seconds. Setting this to
allows the client to ping continuously.
# Transmits
Total packets sent (read only).
# Receives
Total packets received (read only).
%Loss
Percentage loss based on ping returned from host (read only).
If you execute this command, the TA 600 retrieves the configuration file, reboots, then restarts using the
new configuration.
Before using this command, you must have identified a valid TFTP server in 7)736
(59(5
,3
$
''5(66
.
Only one ping session can be active at a time.
To Next Page
Loading...
Need help?
General
