ADTRAN 600 Series User Manual

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 69
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
Appendix F. RFC1483 Quick Start (IP Routing with NAT)
To illustrate the use of NAT, consider the example from Appendix E. To set up a single public address that will be
used to access the public network, you will use the
NAT
menu on the
WAN/ATM/RFC1483 IP
menu.
IP Routing with NAT
Step Action
1
From the
NAT
menu, set
N
ETWORK
A
DDRESS
P
ORT
T
RANSLATION
to
E
NABLED
. (This will enable translation and allow you to enter the NAT
options.)
2
Set P
UBLIC
IP A
DDRESS
M
ODE
to S
PECIFIED
so you can enter your public
address. During transmission, private addresses are translated into this
public (NAPT) address.
You will also need to set up the Translation Table to do translation on
the body of the packets for certain protocols, such as FTP, to work
correctly.
3
From the T
RANSLATION
T
ABLE
menu, create a new entry by arrowing
into the table.
4
For
P
UBLIC
A
DDRESS
M
ODE
, select
NAPT A
DDRESS
to use the
previously specified public address.
5 For P
ROTOCOL
, select TCP.
6 Make sure that T
RANSLATE
B
ODY
is set to Y
ES
.

ADTRAN 600 Series Specifications

General

Brand	ADTRAN
Model	600 Series
Category	Switch
Language	English