ADTRAN NetVanta 3200 series - Netvanta 3430 Front Panel Design; Netvanta 3430 Rear Panel Design; Figure 8. Netvanta 3430 (1202820 G1) Front Panel Layout; Figure 9. Netvanta 3430 (1202820 G1) Rear Panel Layout

Physical Descriptions NetVanta 3200/3300/3400 Series
28 Copyright © 2012 ADTRAN, Inc. 61200860L1-34AB
NetVanta 3430 Front Panel Design
The NetVanta 3430 front panel is shown below. Front panel LED descriptions are given in Table 1 on page 40.
In addition to the LEDs, this front panel contains a
CompactFlash slot for nonvolatile configuration storage and
compressed code storage. ADTRAN supports only ADTRAN-provided CompactFlash (16 MB to 1 GB) (refer
to the list of part numbers on the front cover). Refer to Installing a CompactFlash Card on page 80.
Figure 8. NetVanta 3430 (1202820G1) Front Panel Layout
NetVanta 3430 Rear Panel Design
The NetVanta 3430 rear panel is shown below with a module installed. Appendix A on page 85 provides
pinouts.
Figure 9. NetVanta 3430 (1202820G1) Rear Panel Layout
NetVanta 3430 Rear Panel Interfaces
SLOT 1 NET/DBU Option Slot
The SLOT 1 NET/DBU option slot supports various NIM plug-in option modules. These option
modules are described in the section Option Modules on page 41.
10/100Base-T Ethernet Interfaces
The Ethernet ports (ETH 0/1 and ETH 0/2) are RJ-45 connectors. These ports provide the following:
• 10Base-T or 100Base-T with a single connector
• Auto-negotiation
•CSMA/CD
• IEEE 802.3 compatibility
CONSOLE Interface
The CONSOLE interface is an EIA-232 serial port (DCE) that provides for local management and
configuration (via a DB-9 female connector).
Connection directly to an external modem requires a cross-over cable.
WAN-T1 DBU
CONSOLE
SLOT 1 NET / DBU