NetVanta 3200/3300/3400 Series Physical Descriptions
61200860L1-34AB Copyright © 2012 ADTRAN, Inc. 35
NetVanta 3450 Front Panel Design
The NetVanta 3450 front panel is shown below. Front panel LED descriptions are given in Table 1 on page 40.
Figure 12. NetVanta 3450 Front Panel Layout
CONSOLE Interface
The CONSOLE interface is an EIA-232 serial port (DCE) that provides for local management and
configuration (via a DB-9 female connector).
CompactFlash
The front panel contains a
CompactFlash slot for nonvolatile configuration storage and compressed code
storage. ADTRAN supports only ADTRAN-provided CompactFlash (16 MB to 1 GB) (refer to the list of
part numbers on the front cover). Refer to Installing a CompactFlash Card on page 80.
NetVanta 3450 Rear Panel Design
The NetVanta 3450 rear panel is shown below with a module installed. Appendix A on page 85 provides
pinouts.
Figure 13. NetVanta 3450 Rear Panel Layout
NetVanta 3450 Rear Panel Interfaces
SLOT 1/SLOT 2 NET/DBU Option Slots
The SLOT 1/SLOT 2 NET/DBU option slots support various NIM plug-in option modules. These
option modules are described in the section Option Modules on page 41.
10/100Base-T Ethernet Interfaces
The Ethernet ports (ETH 0/1 and ETH 0/2) are RJ-45 connectors. These ports provide the following:
• 10Base-T or 100Base-T dual stacked connector
• Auto-MDIX
• Auto-negotiation
•CSMA/CD
• IEEE 802.3 compatibility
Connection directly to an external modem requires a cross-over cable.
Status
WAN 2
DBU 2
ETH1
ETH2
CompactFlash
NetVanta 3450
WAN 1
DBU 1
CONSOLE
SLOT 2 NET/DBU
SLOT 1 NET/DBU
ETH 0/2
ETH 0/1
To Next Page
Loading...
