The Advanced
®
3D3/4D3 Service Manual
13
Hazardous Material Cautions
• WARNING: Handle all biohazardous mate-
rials according to established good laborato-
ry practices and follow your institution’s
exposure control plan. Persons handling
human blood and body fluid samples must
be trained in blood-borne hazards and
observe universal precautions. Universal pre-
cautions is an approach to infection control,
where all human blood and body fluids are
treated as if known to be infectious. Use per-
sonal protective equipment such as gloves,
gowns, etc., to prevent exposure. Store bio-
hazardous materials in regulated waste con-
tainers and dispose of these materials in a
safe and acceptable manner that is in com-
pliance with all country, state and local
requirements.
• If a biohazardous material is spilled on or
inside the equipment, decontaminate the
equipment using a 1% bleach solution, or as
outlined by those policies and procedures
established within your institution.
• To avoid injury or fire hazard, do not operate
this product in an explosive atmosphere.
Regulatory Notices
• This product has been designed and manu-
factured in accordance with U.S., Canadian,
and European regulatory requirements as
outlined below. Modifications made to this
product that are not expressly approved in
writing by the manufacturer will void the
user’s authority to operate this product, pre-
viously issued factory approvals, and the
user’s rights under the warranty.
• The distributor or dealer may have applied
additional local, national, or international
approvals to this product. Consult the dis-
tributor or dealer for more information and
documentation.
• Connections to this product must be made
with shielded cables. Use of non-shielded
cables may violate RFI/EMI limits.
U.S. Safety This product has been listed by
ETL testing laboratories as being
in compliance with the require-
ments of UL 3101-1, 1st Edition,
"Electrical Equipment for
Laboratory Use; Part 1: General
Requirements". The "US" in the
lower right of the ETL mark
demonstrates this listing.
Canadian Safety This product has been listed by
ETL testing laboratories as being
in compliance with the require-
ments of CAN/CSA C22.2
No.1010.1-92, "Safety
Requirements for Electrical
Equipment for Measurement,
Control and Laboratory Use;
General Requirements";
Including Amendment Two. The
"C" in the lower left of the ETL
mark demonstrates this listing.
EC Declaration of This product meets the intent of
Conformity - EMC Directive 89/336/EEC for
Electromagnetic Compatibility.
Compliance was demonstrated
using the following standards, as
listed in the Official Journal of
the European Communities:
Consult the Declaration of Con-
formance certificate shipped with
the product for the latest update.
• EN 61326: 1998, Group 1,
Class B, "Electrical Equipment
for Measurement, Control, and
Laboratory Use".
EC Declaration of: This product meets the intent of
Conformity - Low Directive 73/23/EEC, the Low
Voltage Voltage Directive. Compliance
was demonstrated using the fol-
lowing standards as listed in the
Official Journal of the European
Communities: Consult the
Declaration of Conformance cer-
tificate shipped with the product
(if required) for the latest update.
· EN 61010-1 (1993), "Safety
Requirements for Electrical
Equipment for Measurement,
Control and Laboratory Use -
General Requirements";
Including Amendment Two
(1995).
Regulatory
approval type Description
To Next Page
Loading...
