Advanced
®
Cryoscope Model 4250 User’s Guide
• Clean, dry 2.0-mL or 2.5-mL pipette.
Step 3 — Unpack the instrument
To unpack your cryoscope, take the following steps.
a. Carefully unpack your cryoscope, accessories and supplies and
inspect them for shipping damage. Use the enclosed packing list to
verify that all items have been received.
b. Save your cryoscope's shipping boxes and packaging material in
case future transport of the instrument becomes necessary.
c. If any item on the packing list appears to be missing from your ship-
ment, please search carefully through and under all packing materi-
als. If the item is not found, notify your receiving department imme-
diately. Advanced Instruments can only be responsible for items
reported missing within 10 days of a shipment’s arrival.
d. If you receive any damaged items, save the cartons and packing
material those items came in for inspection by the insurer. The carri-
er, dealer, and Advanced Instruments must be notified within 24
hours in order for your warranty and insurance to apply. Have the
transportation company inspect items, fill out a “Report of Concealed
Damage,” and file your claim. Then, notify Advanced Instruments
immediately for repair or replacement.
e. Fill out the warranty card enclosed. Mark the appropriate boxes if
you wish to receive additional information. Mail or fax to 781-320-
8181.
Step 4 — Install the heat transfer fluid
1. Momentarily press the top of the heat transfer compartment door to
release the magnetic latch, then pull the door all the way open.
2. Locate the bagged plastic tubes protruding through the back wall of
the compartment. Remove and discard the plastic bag from the ends
of the tubes.
2
To Next Page
Loading...
Need help?
General
