Table of Contents
iii
Safe Use vii
Symbol Conventions vii
General Cautions viii
FCC Requirements ix
Supplies, Parts & Accessories xi
Calibrators & Standards xiii
Foreword: Theory and Technique xv
Figure 1: Standard Freezing Curve xvii
Chapter 1 — Installation & Setup 1
Step 1 — Find a location for the instrument 1
Step 2 — Obtain additional items 1
Step 3 — Unpack the instrument 2
Step 4 — Install the heat transfer fluid 2
Step 5 — Load printer paper 5
Step 6 — Power up the instrument 5
Step 7 — Prime the heat transfer fluid pump 7
Step 8 — Run a diagnostic test 8
Step 9 — Set date and time 9
Step 10 — Set language preference 9
Step 11 — Check initial factory calibration 9
Step 12 — Proceed to Chapter 2 10
Figure 2: Model 4250 Cryoscope and Accessories 3
Figure 3: Load Printer Paper 6
Figure 4: Prime the Heat Transfer Pump 8
Table 1: Model 4250 Cryoscope Packing List 3
To Next Page
Loading...