25
Fluorophos® ALP Test System Model FLM300 Service Manual
Appendix C
Regulatory notices
This product has been designed and manufactured to
meet the intent of U.S., Canadian, and European
regulatory requirements as outlined below. Modifications
made to this product that are not expressly approved in
writing by the manufacturer will void the user’s authority
to operate this product, previously issued factory
approvals, and the user’s rights under the warranty.
The distributor or dealer may have applied additional
local, national, or international approvals to this product.
Consult the distributor or dealer for more information
and documentation.
Connections to this product must be made with shielded
cables. Use of non-shielded cables may violate RFI/EMI
limits.
Symbol Conventions
This symbol indicates conformity to relevant
European directives.
This symbol indicates the product was
tested to conform to relevant Canadian and
U.S. safety standards by Intertek Testing
Services NA, Inc. The ETL mark is approved
in the United States as a Nationally
Recognized Testing Lab (NRTL) by OSHA,
and in Canada by the Standards Council of
Canada.
Regulatory Notices
Regulatory approval type: Description
U.S. Safety
This product has been listed by ETL testing laboratories as being in compliance with the requirements
of UL61010-1 & 61010-2-010, "Electrical Equipment for Laboratory Use". The "US" in the lower right of
the ETL mark demonstrates this listing.
Canadian Safety
This product has been listed by ETL testing laboratories as being in compliance with the requirements
of CAN/ CSA C22.2 No.61010-1 & 61010-2-010, "Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use”. The "C" in the lower left of the ETL mark demonstrates this
listing.
CE Declaration of Conformity:
EMC
This product meets the intent of Directive 2014/30/EU for Electromagnetic Compatibility. Compliance
was demonstrated using the following standards, as listed in the Ocial Journal of the European
Communities: Consult the Declaration of Conformance certificate shipped with the product for the
latest update. IEC 61326-1: Electrical Equipment for Measurement, Control, and Laboratory Use, Part 1
General Requirements.
CE Declaration of Conformity:
Low Voltage
This product meets the intent of Directive 2014/35/EU, the Low Voltage Directive. Compliance was
demonstrated using the following standards as listed in the Ocial Journal of the European
Communities.Consult the Declaration of Conformance certificate shipped with the product (if required)
for the latest update.
IEC/EN 61010-1, "Safety Requirements for Electrical Equipment for Measurement, Control and
Laboratory Use”.
IEC/EN 61010-2-010, “Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use - Particular Requirements for Laboratory Equipment for the Heating of Materials”.
EC Declaration of Conformity:
WEEE
This product meets the intent of Directive 2012/19/EU for Waste Electrical and Electronic Equipment
(WEEE). Consult the Declaration of Conformance certificate shipped with the product (if required) for
the latest update.
To Next Page
Loading...
