21
Fluorophos® ALP Test System Model FLM300 Service Manual
Appendix A
Product specifications
Item Specification
Electrical Power requirement 100 to 240 VAC (50/60 Hz)
Fuses (2) 250V time delay (Type T): 1 Amp
Power consumption 180W
Memory backup Integral lithium cell; 10-year life (typical); not user-replaceable
Sample Volume See test kit instructions
Sample Capacity Single sample
Readout 20-character vacuum fluorescent display
Units FLU (fluorescence unit)
Results units See test kit instructions
Zeroing Automatic
Resolution 1 FLU
Drift Less than 3 FLU per hour
Cuvette size 12 x 75 mm round
Warm-up time Cuvette chamber 15 minutes
Heating block 30 minutes
Test time 3 minutes
Optics 90° optical bench with light source, fixed filters, detector
Light source Light emitting diode
Filters Excitation 440 nm bandpass
Emission 550 nm longpass
Storage temperature 32 to 158°F / 0 to 70°C
Operating temperature 68 to 85°F / 20 to 29°C
Room humidity 5-80% relative humidity (non-condensing)
Sound level 71.5 dB(A) maximum at operator's position
Communications Integrated thermal printer
DTE EIA-232/V.24(RS-232) serial port (baud selectable: 1200, 2400, 4800,
9600 or 19200)
optional barcode reader
To Next Page
Loading...
