General Troubleshooting
If you are experiencing problems with the operation of the system, you may
reset the system using the isolator switch located next to your air-conditioner’s
outdoor unit. Turn the Isolator switch off, and then try pressing the button to
wake the touch screen. The touch screen should be inoperable. After a 5-minute
delay, turn the isolator back on and allow approximately 3 minutes for the
system to initialize.
• If air volume control is applicable, then increase all zones to 100%.
• If you have wireless wall sensors ensure the batteries aren’t low, if the
batteries are low a warning will be displayed on your HOME screen.
• Check for any fault codes that may be displayed in the SETTINGS screen,
if a fault code is shown contact your dealer and advise them of the fault
code.
• Ensure your e-zone tablet is up to date with the latest app updates from
the Google Play Store, for complete instructions go to
www.advantageair.com.au/update2
• If you are still experiencing difficulties, contact your dealer for further
assistance.
To Previous Page
Loading...