IP Address: This is the IP address of WIRELESS ROUTER as seen on the remote network. If
you set it to 0.0.0.0, WIRELESS ROUTER will get IP address from DHCP Server
automatically.
Subnet Mask: This is the Subnet Mask of WIRELESS ROUTER as seen on the remote
network.
Default Gateway: This is the IP address of the default gateway that allows for contact
between WIRELESS ROUTER and the remote network or host.
Connect to DNS Server automatically: This field allows you to get the DNS IP address from the
remote network automatically
DNS Server 1~2: This field indicates the IP address of DNS that WIRELESS ROUTER
contacts to.
User Name: This field is only available when you set WAN Connection Type as PPPoE or
PPTP.
Password: This field is only available when you set WAN Connection Type as PPPoE.
Idle Disconnect Time in seconds: Disconnect After time of inactivity (in seconds): This field is
optional and allows you to configure to terminate your ISP connection after a specified period
of time. This field is optional and allows you to end your ISP connection after the specified time
of inactivity. A value of zero allows infinite idle time. If Tx Only is checked, the data from
Internet will be skipped for counting idle time. If Tx Only is checked, Internet activity such as
downloading data, is not counted as idle time.
MTU: It means Maximum Transmission Unit (MTU) of PPPoE packet.
Heart-Beat or PPTP/L2TP (VPN) Server: Please enter the server name or server IP of the
authentication server of BigPond server.
Host Name: This field allows you to provide a host name for WIRELESS ROUTER. It is
usually requested by your ISP.
MAC address: This field allows you to provide a unique MAC address for WIRELESS
ROUTER to connect Internet. It is usually requested by your ISP.
26
To Next Page
Loading...
Need help?
General