Advice 600VA - 5. Software and Interface Port; 5.1 Power Monitoring Software; 5.2 Interface Kits; 5.3 Computer Interface Port Characteristics

5. SOFTWARE AND INTERFACE PORT
5.1 Power Monitoring Software: The UPS-MON series software (or other power
monitoring software) is applied standard RS-232 interface to perform monitoring functions,
and then provides an orderly shutdown of a computer in the event of power failure.
Moreover, UPS-MON displays all the diagnostic symptoms on monitor, such as Voltage,
Frequency, Battery level and so on. The software is available for DOS, Windows 3.1x,
Windows 95, Windows NT V3.5 or later, Novell Netware and others. Call your dealer for
more information on computer OS compatible solutions.
5.2 Interface Kits: A series of interface kits is available for operation systems that
provide UPS monitoring. Each interface kit includes the special interface cable required to
convert status signals from the UPS into signals which individual operating system
recognize. The interface cable at UPS side must be connected to REMOTE PORT, at
computer side can be either COM 1 or COM 2. The other installation instructions and
powerful features please refer to READ.ME file.
CAUTION: Use only factory supplied or authorized UPS monitoring cable!
5.3 The characteristics of computer interface port: The computer interface port has
the following characteristics:
The communication port on the back of the UPS may be connected to host computer. This
port allows the computer to monitor the status of the UPS and control the operation of the
UPS in some cases. Its major functions normally include some or all of the following:
To broadcast a warning when power fails.
To close any open file before the battery is exhausted.
To turn-off the UPS.
Some computers are equipped with a special connector to link with the communication port.
In addition, special plug-in cord may be needed. Some computers may need special UPS
monitoring software. Contact your dealer for the details on the various interface Kits.
6. MAINTENANCE AND STORAGE
6.1 Maintenance
6.1.1. Keep the unit clean and vacuum the ventilation intake periodically.
6.1.2. Wipe with soft loose and damp cloth.
6.1.3. Check for loose and bad connections monthly.
6.1.4. Never leave the unit on an uneven surface.
6.1.5. Position the unit to allow at least 10 cm clearance between the rear panel and the
wall. Keep the ventilation intake open.
6.1.6. Avoid direct sunlight, rain and high humidity.
6.1.7. Stay away from fire and extremely hot location.
6.1.8. Do not stack materials on top of the unit.
6.1.9. The unit should not be exposed to corrosive air.