APPENDIX B.1 SPECIFICATION
MODEL 600VA 800VA 1000VA 1250VA 1500VA 2000VA
Capacity 600VA 800VA 1000VA 1250VA 1500VA 2000VA
Voltage 100V, 110V, 120V, 220V, 230V, 240V, +/-25%,Single phase
INPUT
Frequency 50 or 60Hz +/-5% (auto sensing)
Voltage
(on
battery)
Pure sine wave output at nominal +/-5%
Frequency
(on
battery)
50 or 60Hz +/-0.5%
OUTPUT
Voltage
Regulation
AVR
AVR automatically increase output voltage 15% above input
voltage if -9% to-25% of nominal. AVR decrease output voltage
15% below input voltage if+9% to +25% of nominal
Spike Protection 320 Joules, 2ms
Unit Input Fuse for overload & short circuit protection
EMI/RFI filter 10dB at 0.15MHz, 50dB at 30MHz
Overload
Protection
UPS automatic shutdown if overload exceeds 110% of nominal
at
20 second and 125% at 2 seconds.
Transfer Time 2~4 milliseconds, including detection time
PROTECTION
AND
FILTERING
Short Circuit UPS output cut off immediately or input fuse protection
Type Hot swappable, Sealed, Maintenance-free lead acid
Typical
Recharge
Time
4 hours (to 90% of full capacity)
Protection
Automatic self-test & discharge protection, Replace battery
indicator
BATTERY
Back – up Time 10 - 30 minutes (depending on computer load)
Net Weight
Kg
(lbs)
13.8
(30.4)
14.5
(31.9)
15 (33.0)
15.8
(34.8)
25 (55.0) 30 (66.0)
Shipping Weight
Kg(lbs)
14.8
(32.6)
15.5
(34.1)
16 (35.2)
16.8
(37.0)
27 (59.4) 32 (70.4)
Dimension (mm)
W x D x H
140 x 445 x 200 170 x 450 x 215
Input Inlet IEC 320 power inlet
PHYSICAL
Receptacles NEMA 5-15R (115V)/IEC 320 female appliance coupler (230V)
Battery
Back-Up
Slow beeping sound (about 0.25Hz)
Battery Low Rapid beeping sound (about 1.00Hz)
ALARM
Overload Continue beeping sound
INTERFACE RS-232
Interface
Bi-directional communication port
To Next Page
Loading...
