AEE SD21 - Page 16

d
Auto cont. capture: Pictures is captured at intervals of 1, 2, 3, 5, 10, 20, 30 or 60 seconds until the
Stop key is released, the memory card is full, or the battery power is low.
e
Timed shooting: Select the reverse-counting time for auto-shooting (This parameter can be set to OFF,
3s, 5s, or 10s), and choose Timed Shooting and press the M key to return to the preview state. Then
press the Photo key to start reverse counting timer. When the preset time is reached, the
auto-shooting indicator blinks, and the camera takes a picture. To restore to other shooting modes, set
Timed Shooting to OFF. Otherwise, the camera maintains in timed shooting mode.
f
Display time: In the preview state, press the M key. On the setup interface, choose Display Time. If
you set this parameter to ON in advance, the camera automatically records the date and time during
shooting and displays them in the bottom-lower corner of the photo. If you set this parameter to OFF
in advance, the camera does not display the date and time during shooting. (The display time
function is unavailable for photo shooting in 1080i, 960P/50fps,WVGA/100fps, and
WVGA/120fps modes).
Note:
1. The timed shooting function and other shooting functions cannot be simultaneously enabled. Set
Timed shooting to OFF to restore to the other shooting modes. Otherwise, the camera is defaulted in
timed shooting mode.
2. In single shot mode, the Auto cont. capture parameter is automatically set to OFF.
3. If the Auto cont capture parameter is set to 1s, the time display function is unavailable.
 Set system parameters
a Warning tone: Set this parameter to ON to enable the tick tone or OFF to mute the tick tone.
Note: This parameter cannot be set to mute the prompt tones for shooting and video recording. Instead, this
parameter can only be set to mute the tone generated upon pressing a key on the TFT screen and
no-operation prompt tones.
b Status indicator: After choosing the required menu, set this parameter to ON (turning on the status
indicator) or OFF (turning off the status indicator). By default, set this parameter to ON.