Operations
1. Insert a Micro SD card into the SD21 Video Camera
Note: Use a branded Micro SD card, for example, Transcend Class 10 memory card.
2. Powering on the SD21 Video Camera
Turn the power switch to the ON position to power on the SD21 video camera. At this time, the red indicator is
on, and the SD21 video camera changes to the preview state.
Note: a. If the battery power is low, the symbol is displayed on the TFT screen together with a prompt.
b. If no Micro SD card is inserted, no symbol is displayed in the bottom-right corner of the TFT screen.
3. Recording a Video
In the preview state, press the Record key to start video recording. The video recording duration is displayed
in the upper-right part of the TFT screen. The "Video/Audio indicator (green)" and the "Video/Photo indicator
green" on the top of the video camera blink slowly. The recording duration is correctly displayed on the LCD
segment screen. During video recording, the video camera responds only to operations for the zoom out (+)
and zoom in (-) keys. Press the Stop key once to stop and save the currently recorded video file, and the
video indicator (green) on the front side is off. The video camera restores to the preview state. The recording
duration disappears on the LCD segment screen.
Note:
a During video recording, turn the power switch to the OFF position to power off the video camera after
saving the currently recorded file.
b During video recording, if the battery power runs low, the system saves the currently recorded file and
enters standby mode, displaying a prompt of “Low Battery” on the TFT screen, until the video camera is
powered off.
c During video recording, if the Micro SD card is full, the system saves the currently recorded file. The
system also displays a message “Card full” on the TFT screen, indicating that the Micro SD card is full. In
To Next Page
Loading...
