addition, the duration for video recording stops on the LCD segment screen, and the system restores to the
preview state.
d In cyclic recording mode, the system automatically saves a file every 15 minutes. (The cyclic recording
function and the pre-video function cannot be simultaneously enabled.)
e If the D23 backup battery is provided and fully recharged, the video camera can continuously record
video programs for about four hours and record audio programs for about seven hours.
f In WVGA/100 and WVGA/120 modes, the video camera does not support the time display, zooming,
and 180° photo rollover functions. In 1080i/50 and 1080i/60 modes, the video camera does not support the
time display function.
g In audio recording mode, the volume cannot be adjusted by pressing the + or – key. In playback,
however, the volume can adjusted by pressing the + or – key.
h If the video camera provides a TFT screen and is in the preview state, after using a HDMI cable to
connect the video camera to a HD display device, you can perform basic operations for the video camera on
the HD display device (These basic operations, however, cannot be performed if no TFT screen is available
on the video camera).
4. Taking a Picture
Before taking a picture, perform the following operations to set the image resolution.
Press the M key to display the setup interface.
Press the > key to display the camera setup interface ( ).
Press the + or – key and choose Image Resolution.
Press OK to display the resolution setup menu.
You can set the resolution to any of the following three modes:
3M, with an image resolution of 2048 x 1536.
5M, with an image resolution of 2592 x 1944.
8M, with an image resolution of 3200 x 2400.
Four photo shooting modes are available for the video camera.
a. Single shot (the default mode)
To Next Page
Loading...
