In the preview state, press the Photo key once to take a picture while the system generates a click
tone. The green indicator on the front side of the video camera also blinks once (the shooting icon on
the LCD segment screen blinks once), and the video camera restores to the preview state.
b. Continuous capture (three)
On the camera setup interface, press the + or – key and choose Single Photo. Press OK to display
the interface. Press the > key, and choose Continuous capture (three). Press OK again to exit the
interface. Press the M key to exit the camera setup interface. After setting is complete, the SD21 video
camera continuously takes three pictures when you press the Photo key once.
c. Auto cont capture
On the camera setup interface, press the – key and choose Auto Cont Capture. Press OK to set the
time interval for continuous shooting to OFF, 1s, 2s, 3s, 5s, 10s, 20s, 30s or 60s. After press the > key
to set the time interval, press “OK” again to exit the interface. Press the M key to exit the setup
interface. At this time, if you press the Photo key, the SD21 video camera takes a picture at each
interval until you press the Stop key to cancel shooting.
d. Timed shooting
On the camera setup interface, press the + key and choose Timed Shooting. Press OK to set the
time in auto-shooting mode to OFF, 3 s, 5 s, or 10 s. Press the > key, and choose Timed Shooting.
Press OK again to save and exit the interface. Press the M key to exit the camera setup interface.
After setting is complete, the SD21 video camera starts reverse-counting timer when you press the
Photo key once. When the preset time is reached, the SD21 video camera takes a picture.
5. Recording an Audio File
To record an audio file, perform the following operations:
Press the M key on the video camera setup interface, choose Exe., and then press OK to display the
video and audio options.
Press the < or > key, and choose for audio only, and press OK again. The system gets ready for
audio recording.
To Next Page
Loading...
