OFF, the video camera does not display the date and time during video recording. (The display time
function is unavailable for video recording in 1080i, WVGA/100fps, and WVGA/120fps modes.)
Note:
a
In audio recording mode, press the Record key once to start audio recording. The audio recording
duration is displayed in the upper-right corner of the TFT screen, and the green indicator blinks slowly.
Press the Stop key to stop and store the currently recorded audio file. In such a situation, the green
indicator is off, and the red indicator is constantly on (the operation prompt is displayed on the LCD
segment screen), and the video camera restores to the state for audio recording.
b
During audio recording, the video camera responds only to the Stop, Power off keys.
c
When the laser SYNC video function is enabled, the laser icon is displayed in the upper-left corner of
the preview screen, indicating that the video camera is in such a shooting mode. The laser will be
turned when starting video recording, and turned off when stopping video recording.
d
When the pre-video and auto video functions are both enabled, press the Record key to automatically
record the time in reverse counting mode; press the Record key again, the last a few seconds of the
pre-recorded video will be saved as the starting part of the video recording file.
e
Zooming is not required in WVGA/100fps, and WVGA/120fps video recording mode.
ļ Set camera parameters.
a
Resolution: Select the required resolution for shooting. You can set this parameter to 3.0M, 5.0M, or
8.0M.
b
Single shot: When the camera is set to the single-shot (single-key shooting) mode, one picture is
captured when the Photo key is pressed once.
c
Continuous capture (three): When the Photo key is pressed once, three pictures are continuously
captured, and three click tones are also continuously generated.
To Next Page
Loading...
