www.aeg-automotive.com
28
TROUBLESHOOTING
Problem
Possible cause
Solution
The vehicle ignition and the monitor
are switched on and the car is in
The blue LED doesn‘t light up
The 12 V monitor cable plug is not
plugged into the vehicle‘s cigarette
lighter or a 12 V outlet.
Plug the 12 V monitor cable plug into
the cigarette lighter or a 12 V vehicle
outlet.
The fuse inside the 12 V monitor
cable plug is burnt out and must be
replaced.
Replace the defective fuse inside the 12
V monitor cable plug with a new fuse
(also see “Replacing fuses”).
The fuse for the cigarette lighter or
the 12 V socket in the vehicle is burnt
out and must be replaced.
Replace the defective fuse for the ciga-
rette lighter or the 12 V outlet inside
the vehicle‘s fuse box.
The ignition is switched on, the car
is blank.
There is no connection between the
camera and the monitor. The cables
for the camera/radio module are not
loose.
camera and the radio module are cor-
reversing light cables.
The image on the monitor shows
interference.
Other wireless appliances (e.g. mobile
phone) are interfering with the signal
between monitor and camera.
(e.g. mobile phone).
The wireless connection between
monitor and camera is too weak, thus
interfering with data transmission.
Position the transmitter closer to the
monitor.
Bright light is hitting the camera lens.
-
fering light.
To Next Page
Loading...