When the time ends, the signal sounds. The
oven turns off. Press any sensor field to stop
the signal.
7.3 Heat + Hold
Conditions for the function:
• The set temperature is more than 80 °C.
• The function: Duration is set.
The function: Heat + Hold keeps prepared
food warm at 80 °C for 30 minutes. It turns on
after the baking or roasting procedure ends.
You can turn on or turn off the function in the
menu: Basic Settings.
1. Turn on the oven.
2. Select the heating function.
3. Set the temperature above 80 °C.
4. Press
again and again until the display
shows: Heat + Hold.
5. Press to confirm.
When the function ends, a signal sounds.
7.4 Time Extension
The function: Time Extension makes the
heating function continue after the end of
Duration.
Not applicable to heating functions with
the food sensor.
1. When the cooking time ends, a signal
sounds. Press any symbol.
The display shows the message.
2. Press to turn on or to cancel.
3. Set the length of the function.
4. Press
.
8. AUTOMATIC PROGRAMMES
WARNING!
Refer to Safety chapters.
8.1 Recipes with Recipe Automatic
This oven has a set of recipes you can use.
The recipes are fixed and you cannot change
them.
1. Turn on the oven.
2. Select the menu: Recipes. Press to
confirm.
3. Select the category and dish. Press
to confirm.
4. Select a recipe. Press to confirm.
9. USING THE ACCESSORIES
WARNING!
Refer to Safety chapters.
9.1 Inserting accessories
A small indentation at the top increases
safety. The indentations are also anti-tip
devices. The high rim around the shelf
prevents cookware from slipping off the shelf.
Wireshelf
18 ENGLISH
To Next Page
Loading...
Need help?
General
