Top lamp
1. Turn the glass cover to remove it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a halogen, 230 V,
40 W, 300 °C heat-resistant lamp
4. Attach the metal ring to the glass cover
and install it.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem Possible cause Remedy
You cannot activate or operate the
oven.
The oven is not connected to an
electrical supply or it is connected
incorrectly.
Check if the oven is correctly con‐
nected to the electrical supply (refer
to the connection diagram if availa‐
ble).
The oven does not heat up. The oven is turned off. Turn on the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not set. Make sure that the settings are cor‐
rect.
The oven does not heat up. The automatic switch-off is on. Refer to "Automatic switch-off".
The oven does not heat up. The Child Lock is on. Refer to "Using the Child Lock".
The oven does not heat up. The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The food sensor does not operate. The plug of the food sensor is not
correctly installed into the socket.
Put the plug of the food sensor as
far as possible into the socket.
The display shows F111. The plug of the food sensor is not
correctly installed into the socket.
Put the plug of the food sensor as
far as possible into the socket.
The display shows an error code
that is not in this table.
There is an electrical fault.
• Turn off the oven with the house
fuse or the safety switch in the
fuse box and turn it on again.
• If the display shows the error
code again, contact the Custom‐
er Care Department.
26 ENGLISH
To Next Page
Loading...
Need help?
General
