EasyManua.ls Logo

AEG L9WBA61BC - Daily Use - Washing & Drying

AEG L9WBA61BC
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When you activate the
appliance again, the display
shows the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
12.15 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
The display shows 0 min and the
Start/Pause button starts flashing.
The drum still turns at regular intervals
to prevent the creases in the laundry.
The indicator is still on and the
door stays locked.
You must drain the water to open the
door:
1. Touch the Start/Pause button:
If you have set
, the appliance
drains the water and spins.
If you have set , the appliance
only drains the water.
2. If necessary, change the spin speed
proposed by the appliance: touch
the Start/Pause button to pause the
programme; tap on and then on
the Spin Speed bar.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
13. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
13.1 Complete programmes -
Wash and dry
Not all programmes are
compatible with drying
function. The NonStop
3h/3kg programme is
already a complete
wash&dry programme.
You can wash and dry your laundry
setting a «non stop-programme».
Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Turn the programme dial to the
washing programme. The display
shows the default temperature, spin
speed and the maximum
recommended load for washing
phase.
3. Touch the Mode button once to
activate also the drying function. The
Wash and Dry indicators come on.
The indicators and Cupb. appear
on the display. The display also
shows the maximum recommended
load for a washing and drying
programme (e.g. 6 kg for cottons).
ENGLISH 37

Related product manuals