10
W
W
ind the bobbin
ind the bobbin
Release the hand wheel release by tur-
ning the release plate into your direction.
Guide the thread from the thread reel
through the thread retainer (figure 2).
Now, put the end of the thread through
the hole in the bobbin (figure 3).
Put the bobbin onto the bobbin thorn so
that the end of the thread is on top of the
bobbin.
Press the bobbin thorn to the right until
you can hear a clicking. Hold the end of
the thread tight and start the machine.
As soon as the bobbin is winded up a lit-
tle bit you can let the end of the thread
go (figure 4).
If the sewing spool stops, remove the
bobbin and cut the thread (figure 5).
Now, tighten the release plate again.
To Next Page
Loading...
