6
Change the needle
Change the needle
Turn the balance wheel into your direction
until the needle is in the highest position.
Loosen the needle screw and remove the
needle from the fixture (see figure).
After that, put the new needle into the fixture
– with its flat side at the back. Press the nee-
dle as wide as possible up into the needle fix-
ture. Tighten the needle fixture screw secu-
rely again.
Selection of the right needle
Selection of the right needle
The needle’s thickness is displayed
on the shaft.
In any case, do not use a bent or
blunt needle!
To Next Page
Loading...
